Tuesday, December 13, 2016 – 11:12
JACKING BOLTS-IN HOUSE SOLUTIONS
Jacking bolts can be purchased, or made in-house. Here are a few examples of some pusher types:
Check out our Full Article on this by clicking on our Blog section at the top of the page
COUPLING TOLERANCES VS. SHAFT ALIGNMENT TOLERANCES, WHAT’S THE DIFFERENCE?
This question still comes up fairly often in our training classes. If you look at any of the coupling manufactures installation instructions there is a chart for the maximum allowable misalignment based on the coupling size. These tolerances are for the coupling, what about the machines the coupling connects?
