Services Technique Claude Drouin

Services Technique Claude Drouin Logo Industrial Solutions Canada

Coupling Gap

Coupling Gap Blog Post image

One of the most overlooked steps while performing an alignment is the verification of the ‘E’ distance, better known as the coupling gap (between the movable and stationary hub).

Too often this verification is not done after an alignment which can cause very bad surprise after the equipment’s start-up. This distance is a vital part of the alignment process because by making this verification we make sure that there will be no contact between the motor and stationary side in operation  

Share

Leave a Comment

Your email address will not be published. Required fields are marked *

Recent Posts